What to do if your car will not start
Narrow down why a car will not start using a troubleshooting flow that separates battery, starter, fuel and ignition causes, with safe checks you can do yourself before calling for help.
When a car will not start, the cause can usually be narrowed down with a few observations. The sound the engine makes when you turn the key, the state of the dashboard lights and whether the engine turns over at all each point toward a different problem. A dead battery, a failed starter, an empty fuel tank and a faulty ignition component produce different symptoms. A systematic approach saves time, avoids unnecessary repairs and tells the technician what you have already ruled out. Most of the first checks take only a few minutes and require no tools.
Start with what you notice when you turn the key or press the start button. If the dashboard lights are dim or do not come on at all, the battery is the most likely cause. If the lights are bright but the engine does nothing, or makes a single click, the starter or its connection is a suspect. If the engine cranks normally, turning over steadily but never catching, the fuel or ignition system is more likely to be at fault. If the engine starts and then dies, the cause may be fuel delivery, a sensor or an issue with the immobilizer. Write down what you hear and see, because that observation is the foundation for everything that follows.
Check the simple things first
Before looking under the hood, check the basics. Confirm that the car is in park or neutral, and that the brake pedal is pressed for an automatic. A car with a transmission safety switch will not start in gear. Check the fuel gauge, since a surprisingly large number of no-start calls come from an empty tank, and the gauge can be wrong. Look at the key fob and the battery in it, because a weak fob battery can prevent a keyless car from starting. If you have a spare key, try it, since a damaged key can fail to register with the car's immobilizer.
Next, look at the battery terminals. A loose or corroded clamp can stop the flow of current even when the battery is charged. Gently try to move each clamp by hand, and tighten any that move. If there is white or blue crust, clean the terminals with a brush and a solution of baking soda and water, rinse with clean water and dry them before reconnecting. Wear gloves and eye protection while doing this, and disconnect the negative terminal first if you need to remove a clamp.
Work through the likely causes
If the dashboard lights are dim or the engine turns over slowly, the battery is probably weak. A battery that is more than about three to five years old, or one that has been left with the lights on, may not have enough power to start the car. A jump start can confirm the diagnosis. If the car starts with a jump and runs normally afterward, have the battery and the charging system tested, since the alternator may not be keeping the battery charged.
If the engine makes a single loud click and nothing else, the starter solenoid or the starter motor may have failed, or the connection to it may be loose. Tapping the starter with a rubber mallet can sometimes free a sticking component, but that is a temporary measure. Have the starter inspected if the problem repeats. If the engine cranks normally but does not start, the car may be lacking fuel, spark or air. A simple test is to listen for the fuel pump, which usually makes a brief humming sound when the key is turned to the on position. If you hear nothing, the pump, its fuse or its relay may be at fault. Check the fuse box in the owner's manual to find the fuel pump fuse, and inspect it for a broken element. Replace a blown fuse with one of the same rating.
If the engine cranks normally but will not catch, the problem may lie in the ignition or fuel system. Spark plugs, the ignition coils, a clogged fuel filter or a faulty fuel injector can all prevent the engine from starting. These repairs call for diagnosis by a qualified technician, who can test the spark and fuel delivery with the proper equipment.
A troubleshooting flow
Use these steps in order and stop when you find the cause:
- Confirm the car is in park or neutral, the brake is pressed and the fuel tank is not empty.
- Check the key fob battery and try a spare key if you have one.
- Note what the dashboard lights do when you turn the key.
- If the lights are dim or the engine turns slowly, test the battery and the terminals.
- If there is a single click, check the starter connections and consider a starter inspection.
- If the engine cranks normally, listen for the fuel pump and check the relevant fuse.
- If none of the above explains the problem, call for roadside assistance or a tow.
When to stop and call for help
Stop troubleshooting and call for help if you notice a fuel or electrical smell, smoke, a burning odor, or any sign of a fluid leak under the car. Do not attempt complex work near a fuel leak, and do not stand near the engine while it is running. If the car starts but stalls repeatedly, or if the engine warning lights come on, have it inspected before driving it, since a stall in traffic can be dangerous. Keep a record of the symptoms and the checks you made, so that the technician can start from where you left off.
Try the simple checks tonight: confirm the gear position and fuel level, and watch what the dashboard does when you turn the key. Those observations will tell you which branch of the flow to follow, and they will make a call to a mechanic or roadside service much more productive.